SPF Out Performs Fiberglass!

Why Use Foam   |    "R" Value Myth   |    Fiberglass batts   |    SPF Performance   |    4 Types of Insulation

By SPFA / ORNL Test Results

SPFA - Spray Polyurethane Foam Alliance

December, 2005 - SPFA - For years SPF contractors have been frustrated by prescriptive building code requirements that mandated extremely high R-values in attics, particularly in cold climates. For example in Wisconsin, R-values of 49 are prescribed in attics. In order to provide more realistic evaluations of insulation systems, Oak Ridge National Laboratories developed a large scale, attic climate simulator that could provide data on how efficiently insulation systems rated R-values matched up to more real life performance.

In July, 2005, SPFA contracted with R&D Services to test low density, waterblown SPF and 2lb density HFC 245fa blown insulation systems in an attic thermal performance climate simulator at Oak Ridge National Laboratories. The SPF assemblies were compared to a typical blown-in fiberglass insulation attic application.

Three attic insulation systems were tested in the LSCS for both Winter and Summer conditions. The thermal test section has dimensions 8x8 ft. and area of 64 ft2.

  • Loose-fill fiberglass on floor of attic (depth 14 in.)
  • Low-density foam between rafters on the underside of the roof deck (depth 5.5 in.)
  • Medium (2. lb) density foam between rafter on the underside of the roof deck (depth 4.0 in.)

Results:
The tests results demonstrate that both low density and medium (2 lb) density SPF installed to the underside of the roof deck in attic assemblies maintain a much higher effective R-value at both low and high temperatures than the fiberglass insulation system. The SPF systems maintained 74%1 and 83% respectively of reported R-value at low outside temperatures compared to 46% for the fiberglass assembly, and 61% and 67% of reported R-value at high outside temperature compared to 51% for the fiberglass assembly.

Attic temperatures of low density and medium density SPF assemblies averaged 77 to 78 degrees F at high outside temperature and 60 ? 61 degrees F at low outside temperature compared to an average of 107 degrees at high outside temperature and 7 degrees at low outside temperature for the fiberglass assembly.